Details
Ready-to-connect AC switch-plug combination with electronic brake.
Properties, features
- 3-pole switching.
- Switching capacity up to 4 kW
- Braking electronics, braking current up to 16 A adjustable
- Undervoltage release
- Phase inverter
- Connection possibility for thermal contact
- Splash water proof cover
- 1 meter connection cable H07RN-F 5G1,5
Installation / connection (refer to wiring diagram) / brake
The switch is screwed on the housing base. The grid dimensions of the screws is 68 x 68 mm.
The cable outlet is on the side of the housing base, by factory setting on the opposite side of the keypad.
By rotating the base, the cable can be routed to all 4 sides.
The blue wire is not a neutral conductor, it is the connection for the thermal contact.
If the motor does not have a thermal contact, the blue wire has to be connected together with the grey wire on the terminal board.
The braking current is set by factory setting to the lowest braking current. The braking current can be adjusted using a potentiometer. Circular saws should come to a halt in 10 seconds.
Specifications
- Voltage Ue
- 400 V~
- Current le
- 9,0 A
- Contactor
- KB-04, 400V~
- Coil voltage Uc
- 400V~
- Switching capacity
- 4.0 kW 400V~/AC-3
- Type of actuation
- Mechanically on/off
- Connector
- CEE 3P+N+E , 16A
- Housing material
- Polypropylene PP
- Mounting position
- Any
- Protection class
- IP54, splash water proof
- Connection cable
- 1 m H07RN-F 5G1,5
- Mounting dimensions
- 68 x 68 mm
- Klibo-Mod.Nr.
- 0231.0902
Export-Info
- Customs tariff number
- 85362010
- Origin
- Deutschland
Manufacturers Info
Klinger & Born GmbH • In den Schlangenäckern 5 • 64395 Brensbach • Deutschland • www.klibo.de
Notes on delivery times1
The delivery time applies to deliveries to Germany.
Delivery times for other countries can be found at